What an Appliance Service Call Covers
Most appliance repair prices come down to the service call, the labor and the part, with a higher call-out charge for an after-hours visit. On a refrigerator, washer, dryer or oven, the part usually decides whether the total lands near $150 or past $1,000.
- Service call
- $70 to $130 nationally, which typically covers travel in the standard service area, the diagnosis and the first hour of labor. Where the diagnosis is priced on its own, it tends to run $50 to $100.
- Labor past the first hour
- $50 to $125 an hour on national averages, with some price lists running up to $150.
- The part
- The biggest swing in the total. A generic dryer thermal fuse costs $5 to $10 as a part. A refrigerator control board runs $100 to $300 before anyone installs it.
- After-hours call-out
- $140 to $400 nationally. On a small job that charge can top the repair itself, since a dryer thermal fuse (first row of the table below) often costs less installed.
Appliance Part Costs, Small to Large
Common repairs grouped by installed cost, parts and labor together, since the part moves the total more than the appliance does. Each service page has the appliance-by-appliance detail.
| Repair | Typical range | Notes |
|---|---|---|
| Switches and fuses | $75 to $170 | Dryer thermal fuse $75 to $150; microwave door switch $80 to $170 |
| Pumps, belts, valves and igniters | $100 to $350 | Washer drain pump $150 to $350; dryer belt $100 to $250; gas dryer igniter $100 to $250 |
| Motors and control boards | $250 to $750 | Dryer board $250 to $500; washer board $350 to $550; washer motor $300 to $700; fridge board $400 to $750 |
| Sealed-system refrigeration | $400 to $1,400 | Refrigerant leak $400 to $1,100; compressor $700 to $1,250; whole sealed system $600 to $1,400 |
National installed averages; the groups are ours. For one machine in detail, see washer repair costs by part or dryer repair for no heat and long dry times.
Why Some Appliance Repairs Cost More
A written price above these ranges usually has a reason, and you can ask the tech about it on the spot.
- OEM part instead of a generic one
- A generic dryer heating element costs about $15 to $35 as a part, against up to $200 from the maker. That one choice can move the part cost by more than $150. On the visit: Ask which kind the written price assumes, and whether the other kind fits your model.
- Gas instead of electric
- Gas models add parts an electric one doesn't have, like the igniter and the gas valve coils. On a dryer, national averages put gas repairs at about $100 to $450.
- A mounted or built-in unit
- Fixing a microwave mounted over the range runs about $130 to $330, compared with $80 to $180 for a countertop one, since getting the mounted unit down and back up is a two-person job. Mention a built-in fridge or a wall oven on the call too. The cooktop and microwave repair page covers mounted units.
- Work that reaches the gas connection
- Work on a gas appliance connection can need a city plumbing permit, which carries its own fee; the page on gas and refrigerant rules for a repair explains who pulls it.
- An after-hours visit
- The emergency call-out charge in the first list above comes before a single panel comes off. Say how urgent it is when you call. A freezer packed with food is a different call from a dryer that can wait a day.
- Warranty coverage
- Coverage can take the part off the price. LG's current US refrigerator warranty covers the compressor with parts and labor through year 5, then the linear or inverter compressor part alone through year 10. Read us the purchase date with the model number.
Dryer Heating Repair Costs
A dryer that tumbles cold usually comes down to the thermal fuse or the heating element, and even the element tops out around $350 installed. A $420 price sits above either part alone, so ask the tech what else is on it. There's often a fair answer. Lint packed in the vent often blows that fuse, and vent cleaning runs about $80 to $185 by itself, so clearing the vent may belong on the same visit.
A fridge that stopped cooling, priced at $1,050, is sealed-system territory. Ask whether the diagnosis is the compressor, a refrigerant leak or the control board. A board runs $400 to $750 and a compressor $700 to $1,250, and those two lead to different decisions. A new refrigerator runs roughly $675 to $2,500 nationally, so give the repair or replace guide a look before you say yes.
A price well under the range deserves a question as well. It may assume a generic part, which is fine as long as you know that going in.
What an Appliance Repair Estimate Should List
You'll have the price in writing before the tech starts the repair. These are the lines worth reading closely.
- The service call amount, and whether it comes off the total if you go ahead
- The part by name, and whether it is OEM or generic
- Labor shown apart from the part
- How long the part is covered, and how long the labor
- Whether a return visit for the same fault costs anything
Which Appliance Costs the Most to Fix?
Refrigerators top the national averages, and sealed-system work, the last row of the parts table, sits well above a fridge's usual range. The refrigerator and freezer repair page prices it part by part.
- Refrigerator
- $300 average; most jobs $125 to $500
- Freezer
- $250 average
- Stove or oven
- $250 average; see oven, range and stove repair
- Washer, dryer, dishwasher
- $200 average each
- Microwave, garbage disposal
- $175 average each
Appliance Repair Cost Questions
How much is a service call for appliance repair in Houston?
About $70 to $130 on national averages, and that usually covers the trip, the diagnosis and the first hour of labor. Nobody publishes a Houston average. An after-hours call-out runs $140 to $400. The service call shows on your written price next to the part and the labor.
How much does refrigerator repair cost?
Most refrigerator repairs run $125 to $500 nationally, with a $300 average. Fans, gaskets and defrost parts land in that band. Sealed-system work (a compressor, a refrigerant leak or a coil) runs $400 to $1,400, and that's where repair or replace turns into a real question.
Is the diagnostic fee worth it if I might not fix it?
Usually, yes. The diagnosis turns a guess into a named part and a written price, which is the number you weigh against a new appliance. Without it, a dryer that won't heat could be a $75 fuse or a $350 element.
Can you give me a price over the phone?
Not a firm one, because the same symptom can trace back to parts with very different prices. On the call we'll take the brand, the symptom and any error code, and you get the repair priced in writing once the part has been tested.
Does a manufacturer warranty lower the cost?
It can, by a lot. Maytag, for one, backs its major appliances built after 2017 with ten years of limited parts coverage. Parts-only coverage still leaves the labor, so the purchase date is worth having when you call.
